P0990: Trans Fluid Press Sensor / Switch 'E', Signal too High

Complete diagnostic information, symptoms, and potential causes

⚠️

Manufacturer-Specific Variations

This code (P0990) may have different meanings or additional parameters depending on your vehicle's make, model, and year. Always verify with your vehicle's service manual or a qualified technician before attempting repairs.

P0990
Powertrain Code

Trans Fluid Press Sensor / Switch 'E', Signal too High

Transmission Hydraulic SystemMEDIUM👁 Views: 47

Description

Trans Fluid Press Sensor / Switch 'E', Signal too High

Common Symptoms

  • Check Engine Light for trans fluid pressure sensor E signal too high
  • Excessive pressure sensor E signals
  • Hydraulic pressure overvoltage warnings
  • Fluid pressure protection errors for sensor E
  • Pressure sensing regulation problems

Possible Causes

  • Overvoltage supply to trans fluid pressure sensor E
  • Sensor E output signal excessive
  • Short circuit in pressure sensor E wiring
  • Pressure sensor E internal short circuit
  • Voltage regulator problems for pressure sensor E

Diagnosis Steps

  1. Check trans fluid pressure sensor E signal for overvoltage
  2. Verify voltage supply to pressure sensor E not excessive
  3. Test for shorts in pressure sensor E circuit
  4. Check pressure sensor E internal resistance
  5. Verify voltage regulation for pressure sensor E
  6. Test reference voltage to pressure sensor E

Repair Solutions

  • Fix overvoltage supply to trans fluid pressure sensor E
  • Replace pressure sensor E with excessive output
  • Repair short circuit in pressure sensor E wiring
  • Replace pressure sensor E with internal short
  • Fix voltage regulator problems for pressure sensor E
  • Correct faulty reference voltage to pressure sensor E

Prevention Tips

  • Monitor trans fluid pressure sensor signals for overvoltage
  • Maintain proper voltage regulation
  • Check for wiring shorts regularly
  • Address excessive signals immediately
  • Protect pressure sensor circuits from overvoltage
⚡

Working with ECU firmware? Remove DTCs directly from firmware files

Our free Firmware DTC Remover detects and removes hardcoded fault codes directly from ECU firmware files — no software needed. Supports BMW / MINI, VAG (VW, Audi, Porsche, Skoda, Seat, Cupra), PSA (Peugeot, Citroën, DS), Mercedes-Benz, Renault / Dacia / Samsung, Ford, Kia / Hyundai, Land Rover / Jaguar (EDC16, EDC17, MD1, MEVD17, MSV/MSD (7X/8X/9X), MS45, DCM3.7, DCM6.x, PCR2.1, DCM3.4, SID201, SID208, SID803/803A, CRD1.xx, CRD2.xx, CRD3.xx, SID3xx, SID202-SID206, SID209-SID211, DCM3.5, EMS22xx, EMS24xx (test), SIM210 (test), SIM28/29 (test), DCM3.2, SIM2K, SID20x, MED17). Free: 3 removals/day.

Try DTC Remover — Free →