P0991: Trans Fluid Press Sensor / Switch 'E', Circuit Intermittent
Complete diagnostic information, symptoms, and potential causes
Manufacturer-Specific Variations
This code (P0991) may have different meanings or additional parameters depending on your vehicle's make, model, and year. Always verify with your vehicle's service manual or a qualified technician before attempting repairs.
Trans Fluid Press Sensor / Switch 'E', Circuit Intermittent
Description
Trans Fluid Press Sensor / Switch 'E', Circuit Intermittent
Common Symptoms
- Check Engine Light for trans fluid pressure sensor E circuit intermittent
- Intermittent pressure sensor E signals
- Hydraulic pressure consistency problems
- Fluid pressure reliability errors
- Pressure sensing stability warnings
Possible Causes
- Intermittent wiring connections in pressure sensor E circuit
- Loose connectors for pressure sensor E
- Sensor E intermittent internal connections
- Vibration affecting pressure sensor E circuit
- Corrosion causing intermittent contact for pressure sensor E
Diagnosis Steps
- Test trans fluid pressure sensor E circuit for intermittent operation
- Check for loose wiring connections in pressure sensor E circuit
- Verify connector security for pressure sensor E
- Test sensor E internal connections for intermittency
- Check for vibration affecting pressure sensor E circuit
- Inspect for corrosion causing intermittent contact
Repair Solutions
- Fix intermittent wiring connections in pressure sensor E circuit
- Secure loose connectors for trans fluid pressure sensor E
- Replace sensor E with intermittent internal connections
- Address vibration affecting pressure sensor E circuit
- Clean corrosion causing intermittent contact
- Secure wiring harness to prevent movement
Prevention Tips
- Regular pressure sensor circuit stability checks
- Monitor hydraulic pressure signal consistency
- Maintain secure electrical connections
- Address intermittent warnings promptly
- Check wiring harness security
Working with ECU firmware? Remove DTCs directly from firmware files
Our free Firmware DTC Remover detects and removes hardcoded fault codes directly from ECU firmware files — no software needed. Supports BMW / MINI, VAG (VW, Audi, Porsche, Skoda, Seat, Cupra), PSA (Peugeot, Citroën, DS), Mercedes-Benz, Renault / Dacia / Samsung, Ford, Kia / Hyundai, Land Rover / Jaguar (EDC16, EDC17, MD1, MEVD17, MSV/MSD (7X/8X/9X), MS45, DCM3.7, DCM6.x, PCR2.1, DCM3.4, SID201, SID208, SID803/803A, CRD1.xx, CRD2.xx, CRD3.xx, SID3xx, SID202-SID206, SID209-SID211, DCM3.5, EMS22xx, EMS24xx (test), SIM210 (test), SIM28/29 (test), DCM3.2, SIM2K, SID20x, MED17). Free: 3 removals/day.