P0989: Trans Fluid Press Sensor / Switch 'E', Signal too Low

Complete diagnostic information, symptoms, and potential causes

⚠️

Manufacturer-Specific Variations

This code (P0989) may have different meanings or additional parameters depending on your vehicle's make, model, and year. Always verify with your vehicle's service manual or a qualified technician before attempting repairs.

P0989
Powertrain Code

Trans Fluid Press Sensor / Switch 'E', Signal too Low

Transmission Hydraulic SystemMEDIUM👁 Views: 44

Description

Trans Fluid Press Sensor / Switch 'E', Signal too Low

Common Symptoms

  • Check Engine Light for trans fluid pressure sensor E signal too low
  • Weak pressure sensor E signals
  • Hydraulic pressure low voltage warnings
  • Fluid pressure signal problems for sensor E
  • Pressure sensing voltage errors

Possible Causes

  • Low voltage supply to trans fluid pressure sensor E
  • Sensor E output signal weak
  • High resistance in pressure sensor E circuit
  • Pressure sensor E internal failure
  • Ground connection problems for pressure sensor E

Diagnosis Steps

  1. Check trans fluid pressure sensor E signal voltage levels
  2. Verify voltage supply to pressure sensor E
  3. Test circuit resistance in pressure sensor E wiring
  4. Check pressure sensor E ground connections
  5. Inspect pressure sensor E for contamination
  6. Test sensor E output characteristics

Repair Solutions

  • Fix low voltage supply to trans fluid pressure sensor E
  • Replace pressure sensor E with weak output
  • Repair high resistance in pressure sensor E circuit
  • Address ground connection problems for pressure sensor E
  • Clean contaminated pressure sensor E connections
  • Replace internally failed trans fluid pressure sensor E

Prevention Tips

  • Monitor trans fluid pressure sensor signals regularly
  • Maintain clean electrical connections
  • Check voltage supplies during maintenance
  • Address weak signals immediately
  • Protect pressure sensor circuits from contamination
⚡

Working with ECU firmware? Remove DTCs directly from firmware files

Our free Firmware DTC Remover detects and removes hardcoded fault codes directly from ECU firmware files — no software needed. Supports BMW / MINI, VAG (VW, Audi, Porsche, Skoda, Seat, Cupra), PSA (Peugeot, Citroën, DS), Mercedes-Benz, Renault / Dacia / Samsung, Ford, Kia / Hyundai, Land Rover / Jaguar (EDC16, EDC17, MD1, MEVD17, MSV/MSD (7X/8X/9X), MS45, DCM3.7, DCM6.x, PCR2.1, DCM3.4, SID201, SID208, SID803/803A, CRD1.xx, CRD2.xx, CRD3.xx, SID3xx, SID202-SID206, SID209-SID211, DCM3.5, EMS22xx, EMS24xx (test), SIM210 (test), SIM28/29 (test), DCM3.2, SIM2K, SID20x, MED17). Free: 3 removals/day.

Try DTC Remover — Free →