U11C4: Multi-Manufacturer: U11C4 (Dodge CAN Bus Error)
Complete diagnostic information, symptoms, and potential causes
Manufacturer-Specific Variations
This code (U11C4) may have different meanings or additional parameters depending on your vehicle's make, model, and year. Network communication codes (U-codes) are particularly manufacturer-specific and may require specialized diagnostic tools. Always verify with your vehicle's service manual or a qualified technician before attempting repairs.
Multi-Manufacturer: U11C4 (Dodge CAN Bus Error)
Description
U11C4 appears in Dodge vehicles with multiple CAN bus errors. Documented rodent damage case - check wiring harness and clockspring.
Common Symptoms
- FOR DODGE: Multiple DTCs including U0002 (High Speed CAN Bus Performance)
- Service power steering light
- ESC light
- Autostick not available
- Reverse gear unavailable
- Blinking red gear selector
- AC compressor not running
- First sign: wiper activates when turn signal used
Possible Causes
- FOR DODGE: Rodent-chewed CAN bus wiring (documented case)
- Damaged wiring harness
- Corroded connections
- Faulty clockspring assembly
- Intermittent CAN bus communication
Diagnosis Steps
- IDENTIFY MANUFACTURER FIRST - U11C4 documented in Dodge Dart forum cases
- Check for multiple related codes - indicates widespread communication failure
- Inspect wiring harness for rodent damage - especially in engine compartment
- Check multifunction stalk operation - wiper activation with turn signal was first sign
- Test CAN bus continuity and resistance
- Inspect clockspring assembly for damage
Repair Solutions
- FOR DODGE: Repair rodent-chewed CAN bus wiring (documented fix)
- Replace damaged wiring sections
- Replace clockspring assembly if fried
- Insurance may not cover rodent damage without photo evidence
- Clear all codes after repairs and verify CAN bus communication
Prevention Tips
- First sign of CAN bus issues may be wiper activation with turn signals
- Rodent damage often requires visual inspection - look for chewed wires
- Multiple U-codes appearing simultaneously suggests bus-wide issue
Working with ECU firmware? Remove DTCs directly from firmware files
Our free Firmware DTC Remover detects and removes hardcoded fault codes directly from ECU firmware files — no software needed. Supports BMW / MINI, VAG (VW, Audi, Porsche, Skoda, Seat, Cupra), PSA (Peugeot, Citroën, DS), Mercedes-Benz, Renault / Dacia / Samsung, Ford, Kia / Hyundai, Land Rover / Jaguar (EDC16, EDC17, MD1, MEVD17, MSV/MSD (7X/8X/9X), MS45, DCM3.7, DCM6.x, PCR2.1, DCM3.4, SID201, SID208, SID803/803A, CRD1.xx, CRD2.xx, CRD3.xx, SID3xx, SID202-SID206, SID209-SID211, DCM3.5, EMS22xx, EMS24xx (test), SIM210 (test), SIM28/29 (test), DCM3.2, SIM2K, SID20x, MED17). Free: 3 removals/day.