U11C2: Multi-Manufacturer: U11C2 (Jeep Transmission Message)

Complete diagnostic information, symptoms, and potential causes

⚠️

Manufacturer-Specific Variations

This code (U11C2) may have different meanings or additional parameters depending on your vehicle's make, model, and year. Network communication codes (U-codes) are particularly manufacturer-specific and may require specialized diagnostic tools. Always verify with your vehicle's service manual or a qualified technician before attempting repairs.

U11C2
Network Communication Code

Multi-Manufacturer: U11C2 (Jeep Transmission Message)

Network CommunicationsHIGH👁 Views: 85

Description

U11C2 indicates Jeep implausible/missing transmission message. Check TCM fuse (fuse 60 in PDC) - documented fix for no-start conditions.

Common Symptoms

  • FOR JEEP: Sudden no-start condition
  • Transmission defaults to PARK
  • Engine cranks but won't start
  • Accompanied by U0101 - Lost Communication with TCM

Possible Causes

  • FOR JEEP: Blown TCM fuse (fuse 60 in PDC)
  • Intermittent power to TCM
  • Damaged wiring or connections
  • Faulty TCM

Diagnosis Steps

  1. IDENTIFY MANUFACTURER FIRST - U11C2 documented in 2014 Jeep Grand Cherokee cases
  2. Check power and ground at TCM - look for erratic voltage
  3. Locate TCM fuse in Power Distribution Center (near battery in engine compartment)
  4. Check fuse for power on both sides - may appear good but be burned
  5. Inspect PDC fuse terminals for cleanliness and tightness
  6. Pull fuse and inspect closely - may look slightly burned even if terminals are clean

Repair Solutions

  • FOR JEEP: Replace blown TCM fuse (fuse 60 in PDC) - documented fix from ALLDATA tech tip
  • Clear DTCs after fuse replacement
  • If fuse blows again, trace for short circuit in TCM power circuit

Prevention Tips

  • This code can cause sudden no-start - check TCM fuse first before more expensive diagnosis
  • Regular inspection of fuses in PDC can prevent unexpected failures
⚡

Working with ECU firmware? Remove DTCs directly from firmware files

Our free Firmware DTC Remover detects and removes hardcoded fault codes directly from ECU firmware files — no software needed. Supports BMW / MINI, VAG (VW, Audi, Porsche, Skoda, Seat, Cupra), PSA (Peugeot, Citroën, DS), Mercedes-Benz, Renault / Dacia / Samsung, Ford, Kia / Hyundai, Land Rover / Jaguar (EDC16, EDC17, MD1, MEVD17, MSV/MSD (7X/8X/9X), MS45, DCM3.7, DCM6.x, PCR2.1, DCM3.4, SID201, SID208, SID803/803A, CRD1.xx, CRD2.xx, CRD3.xx, SID3xx, SID202-SID206, SID209-SID211, DCM3.5, EMS22xx, EMS24xx (test), SIM210 (test), SIM28/29 (test), DCM3.2, SIM2K, SID20x, MED17). Free: 3 removals/day.

Try DTC Remover — Free →