U11AB: Multi-Manufacturer: U11AB (BMW Transmission Message Missing)

Complete diagnostic information, symptoms, and potential causes

⚠️

Manufacturer-Specific Variations

This code (U11AB) may have different meanings or additional parameters depending on your vehicle's make, model, and year. Network communication codes (U-codes) are particularly manufacturer-specific and may require specialized diagnostic tools. Always verify with your vehicle's service manual or a qualified technician before attempting repairs.

U11AB
Network Communication Code

Multi-Manufacturer: U11AB (BMW Transmission Message Missing)

Network CommunicationsLOW👁 Views: 39

Description

U11AB indicates BMW DME-EGS communication failure - message completely missing. Check transmitting module (EGS) and CAN bus.

Common Symptoms

  • FOR BMW: No apparent symptoms - emissions warning lamps off, no power reduction, no CC message
  • Code stored in DME fault memory when message not received in specified time

Possible Causes

  • FOR BMW: Fault with transmitting control module (EGS/twin-clutch gearbox)
  • Message (request, torque, crankshaft, gearbox, 0x0B0) completely missing
  • System voltage must be >10V, terminal condition 15, 750 sec time condition
  • Fault logs after 0.8 seconds present

Diagnosis Steps

  1. IDENTIFY MANUFACTURER FIRST - U11AB has specific BMW meaning
  2. FOR BMW: Verify terminal 15 condition and system voltage >10V
  3. Carry out system analysis using BMW diagnostic equipment
  4. Check for complete loss of message 0x0B0 from EGS to DME
  5. Diagnose transmitting module (EGS/twin-clutch gearbox)
  6. Inspect CAN bus wiring between DME and EGS for opens/shorts

Repair Solutions

  • FOR BMW: Address fault with transmitting control module (EGS/twin-clutch gearbox)
  • Repair CAN bus communication issues causing complete message loss
  • Replace faulty EGS module if internal failure detected
  • Note: No breakdown notice or driver information typically associated

Prevention Tips

  • U11AB indicates COMPLETE message loss (vs U11AA which is message not updating)
  • Focus diagnosis on transmitting module (EGS) first
  • Check system voltage >10V for proper module communication
⚡

Working with ECU firmware? Remove DTCs directly from firmware files

Our free Firmware DTC Remover detects and removes hardcoded fault codes directly from ECU firmware files — no software needed. Supports BMW / MINI, VAG (VW, Audi, Porsche, Skoda, Seat, Cupra), PSA (Peugeot, Citroën, DS), Mercedes-Benz, Renault / Dacia / Samsung, Ford, Kia / Hyundai, Land Rover / Jaguar (EDC16, EDC17, MD1, MEVD17, MSV/MSD (7X/8X/9X), MS45, DCM3.7, DCM6.x, PCR2.1, DCM3.4, SID201, SID208, SID803/803A, CRD1.xx, CRD2.xx, CRD3.xx, SID3xx, SID202-SID206, SID209-SID211, DCM3.5, EMS22xx, EMS24xx (test), SIM210 (test), SIM28/29 (test), DCM3.2, SIM2K, SID20x, MED17). Free: 3 removals/day.

Try DTC Remover — Free →