U11AA: Multi-Manufacturer: U11AA (BMW Transmission Message)

Complete diagnostic information, symptoms, and potential causes

⚠️

Manufacturer-Specific Variations

This code (U11AA) may have different meanings or additional parameters depending on your vehicle's make, model, and year. Network communication codes (U-codes) are particularly manufacturer-specific and may require specialized diagnostic tools. Always verify with your vehicle's service manual or a qualified technician before attempting repairs.

U11AA
Network Communication Code

Multi-Manufacturer: U11AA (BMW Transmission Message)

Network CommunicationsLOW👁 Views: 41

Description

U11AA indicates BMW DME-EGS communication timeout - message not up-to-date. Check transmitting module (EGS) and CAN bus.

Common Symptoms

  • FOR BMW: No apparent symptoms - emissions warning lamps off, no power reduction, no CC message
  • Code stored in DME fault memory without driver noticeable effects

Possible Causes

  • FOR BMW: Fault with transmitting control module (EGS/twin-clutch gearbox)
  • Message keep-alive counter has not timed the message within specification
  • System voltage must be >10V, terminal condition 15, 750 sec time condition
  • Fault logs after 0.4 seconds present

Diagnosis Steps

  1. IDENTIFY MANUFACTURER FIRST - U11AA has specific BMW meaning
  2. FOR BMW: Verify terminal 15 condition and system voltage >10V
  3. Carry out system analysis using BMW diagnostic equipment
  4. Check communication between DME and EGS/twin-clutch gearbox
  5. Monitor message currency for request/torque/crankshaft data (0x0B0)
  6. If transmitting module fault suspected, diagnose EGS module

Repair Solutions

  • FOR BMW: Address fault with transmitting control module (EGS/twin-clutch gearbox)
  • Repair CAN bus communication issues between DME and EGS
  • Update/reprogram EGS module if software-related
  • Note: No breakdown notice or driver information typically associated

Prevention Tips

  • This BMW code often stores without noticeable symptoms - may be intermittent
  • Focus diagnosis on transmitting module (EGS) rather than receiver (DME)
  • Check system voltage - must be >10V for proper operation
⚡

Working with ECU firmware? Remove DTCs directly from firmware files

Our free Firmware DTC Remover detects and removes hardcoded fault codes directly from ECU firmware files — no software needed. Supports BMW / MINI, VAG (VW, Audi, Porsche, Skoda, Seat, Cupra), PSA (Peugeot, Citroën, DS), Mercedes-Benz, Renault / Dacia / Samsung, Ford, Kia / Hyundai, Land Rover / Jaguar (EDC16, EDC17, MD1, MEVD17, MSV/MSD (7X/8X/9X), MS45, DCM3.7, DCM6.x, PCR2.1, DCM3.4, SID201, SID208, SID803/803A, CRD1.xx, CRD2.xx, CRD3.xx, SID3xx, SID202-SID206, SID209-SID211, DCM3.5, EMS22xx, EMS24xx (test), SIM210 (test), SIM28/29 (test), DCM3.2, SIM2K, SID20x, MED17). Free: 3 removals/day.

Try DTC Remover — Free →