U11A0: Multi-Manufacturer: U11A0 (Dodge HO2S Low Voltage)

Complete diagnostic information, symptoms, and potential causes

⚠️

Manufacturer-Specific Variations

This code (U11A0) may have different meanings or additional parameters depending on your vehicle's make, model, and year. Network communication codes (U-codes) are particularly manufacturer-specific and may require specialized diagnostic tools. Always verify with your vehicle's service manual or a qualified technician before attempting repairs.

U11A0
Network Communication Code

Multi-Manufacturer: U11A0 (Dodge HO2S Low Voltage)

Network CommunicationsMEDIUM👁 Views: 27

Description

U11A0 indicates Dodge HO2S Bank 2 Sensor 1 circuit low voltage. Check sensor wiring, reference circuit, and ECM.

Common Symptoms

  • FOR DODGE: Check Engine Light, poor fuel economy, possible failed emissions test
  • Code sets when HO2S voltage <50 mV under specific conditions

Possible Causes

  • FOR DODGE: HO2S low reference circuit open/high resistance
  • HO2S signal circuit short to ground or voltage
  • HO2S signal circuit open/high resistance
  • Failed HO2S sensor
  • Failed ECM

Diagnosis Steps

  1. IDENTIFY MANUFACTURER FIRST - U11A0 has specific meaning for Dodge
  2. FOR DODGE: Verify engine operating in Closed Loop, ignition 10-18V, fuel level >10%, TP 3-70% for 2 seconds
  3. Check HO2S signal circuit for shorts to ground/voltage
  4. Test HO2S low reference circuit for open/high resistance
  5. Monitor HO2S voltage - should be >50 mV under test conditions
  6. If wiring OK, suspect HO2S or ECM failure

Repair Solutions

  • FOR DODGE: Repair open/high resistance in HO2S low reference circuit
  • Repair short to ground/voltage in HO2S signal circuit
  • Replace faulty HO2S sensor Bank 2 Sensor 1
  • Replace ECM if all other checks pass

Prevention Tips

  • Always verify manufacturer before diagnosing U11A0
  • For Dodge, check freeze frame data for conditions present when code set
⚡

Working with ECU firmware? Remove DTCs directly from firmware files

Our free Firmware DTC Remover detects and removes hardcoded fault codes directly from ECU firmware files — no software needed. Supports BMW / MINI, VAG (VW, Audi, Porsche, Skoda, Seat, Cupra), PSA (Peugeot, Citroën, DS), Mercedes-Benz, Renault / Dacia / Samsung, Ford, Kia / Hyundai, Land Rover / Jaguar (EDC16, EDC17, MD1, MEVD17, MSV/MSD (7X/8X/9X), MS45, DCM3.7, DCM6.x, PCR2.1, DCM3.4, SID201, SID208, SID803/803A, CRD1.xx, CRD2.xx, CRD3.xx, SID3xx, SID202-SID206, SID209-SID211, DCM3.5, EMS22xx, EMS24xx (test), SIM210 (test), SIM28/29 (test), DCM3.2, SIM2K, SID20x, MED17). Free: 3 removals/day.

Try DTC Remover — Free →