P2104: Throttle Valve Actuator Module (J338), Forced Idle
Complete diagnostic information, symptoms, and potential causes
Manufacturer-Specific Variations
This code (P2104) may have different meanings or additional parameters depending on your vehicle's make, model, and year. Always verify with your vehicle's service manual or a qualified technician before attempting repairs.
Throttle Valve Actuator Module (J338), Forced Idle
Description
Throttle Actuator Control Module - Forced to Idle Mode
Common Symptoms
- Check Engine Light
- Engine stuck at idle
- No throttle response
- Reduced power mode
Possible Causes
- Throttle actuator control module forced to idle mode
- Safety system activation
- Multiple sensor failures
- System malfunctions
- Control module errors
Diagnosis Steps
- Check throttle actuator control module status
- Monitor throttle position commands
- Test throttle position sensors
- Check for related fault codes
- Test control module operation
Repair Solutions
- Address root cause of forced idle mode
- Replace faulty sensors
- Repair control module issues
- Fix safety system problems
- Reset throttle system
Prevention Tips
- Regular throttle system diagnostics
- Address sensor warnings promptly
- Keep throttle body clean
- Perform system resets after repairs
Working with ECU firmware? Remove DTCs directly from firmware files
Our free Firmware DTC Remover detects and removes hardcoded fault codes directly from ECU firmware files — no software needed. Supports BMW / MINI, VAG (VW, Audi, Porsche, Skoda, Seat, Cupra), PSA (Peugeot, Citroën, DS), Mercedes-Benz, Renault / Dacia / Samsung, Ford, Kia / Hyundai, Land Rover / Jaguar (EDC16, EDC17, MD1, MEVD17, MSV/MSD (7X/8X/9X), MS45, DCM3.7, DCM6.x, PCR2.1, DCM3.4, SID201, SID208, SID803/803A, CRD1.xx, CRD2.xx, CRD3.xx, SID3xx, SID202-SID206, SID209-SID211, DCM3.5, EMS22xx, EMS24xx (test), SIM210 (test), SIM28/29 (test), DCM3.2, SIM2K, SID20x, MED17). Free: 3 removals/day.