P171E: Transmission input shaft speed sensor 2 - no signal
Complete diagnostic information, symptoms, and potential causes
Manufacturer-Specific Variations
This code (P171E) may have different meanings or additional parameters depending on your vehicle's make, model, and year. Always verify with your vehicle's service manual or a qualified technician before attempting repairs.
Transmission input shaft speed sensor 2 - no signal
Description
Transmission input shaft speed sensor 2 - no signal
Common Symptoms
- Check Engine Light
- Transmission shift issues
- Possible torque converter problems
- Speed calculation errors
Possible Causes
- Faulty transmission input shaft speed sensor 2
- Sensor wiring open circuit
- Sensor connection problems
- Sensor internal failure
- Signal processing issues
Diagnosis Steps
- Test transmission input shaft speed sensor 2
- Check sensor wiring for continuity
- Test sensor electrical connections
- Monitor sensor signal while driving
- Compare with input shaft speed sensor 1
Repair Solutions
- Replace faulty input shaft speed sensor 2
- Repair wiring open circuits
- Fix connection problems
- Address signal processing issues
Prevention Tips
- Regular transmission sensor checks
- Protect wiring harness from damage
- Address speed sensor warnings early
Working with ECU firmware? Remove DTCs directly from firmware files
Our free Firmware DTC Remover detects and removes hardcoded fault codes directly from ECU firmware files — no software needed. Supports BMW / MINI, VAG (VW, Audi, Porsche, Skoda, Seat, Cupra), PSA (Peugeot, Citroën, DS), Mercedes-Benz, Renault / Dacia / Samsung, Ford, Kia / Hyundai, Land Rover / Jaguar (EDC16, EDC17, MD1, MEVD17, MSV/MSD (7X/8X/9X), MS45, DCM3.7, DCM6.x, PCR2.1, DCM3.4, SID201, SID208, SID803/803A, CRD1.xx, CRD2.xx, CRD3.xx, SID3xx, SID202-SID206, SID209-SID211, DCM3.5, EMS22xx, EMS24xx (test), SIM210 (test), SIM28/29 (test), DCM3.2, SIM2K, SID20x, MED17). Free: 3 removals/day.