P1131: Oxygen (Lambda) Sensor; Bank-2 Sonde-1, Internal Resistance too High
Complete diagnostic information, symptoms, and potential causes
Manufacturer-Specific Variations
This code (P1131) may have different meanings or additional parameters depending on your vehicle's make, model, and year. Always verify with your vehicle's service manual or a qualified technician before attempting repairs.
Oxygen (Lambda) Sensor; Bank-2 Sonde-1, Internal Resistance too High
Description
Oxygen (Lambda) Sensor Bank-2 Sensor-1, Internal Resistance too High
Common Symptoms
- Check Engine Light
- Possible poor fuel economy
- Slow sensor response on bank 2
- Emission test failures
Possible Causes
- Aging oxygen sensor on bank 2 upstream
- Contaminated sensor element
- Internal sensor damage
- High resistance in sensor circuit
Diagnosis Steps
- Test bank 2 upstream oxygen sensor internal resistance
- Check sensor response time
- Inspect sensor for contamination
- Compare with other sensors
- Monitor sensor voltage patterns
Repair Solutions
- Replace faulty Bank 2 Sensor 1 oxygen sensor
- Address contamination sources if present
- Ensure proper sensor installation
Prevention Tips
- Use correct fuel type
- Address engine burning oil issues
- Replace oxygen sensors at recommended intervals
Working with ECU firmware? Remove DTCs directly from firmware files
Our free Firmware DTC Remover detects and removes hardcoded fault codes directly from ECU firmware files — no software needed. Supports BMW / MINI, VAG (VW, Audi, Porsche, Skoda, Seat, Cupra), PSA (Peugeot, Citroën, DS), Mercedes-Benz, Renault / Dacia / Samsung, Ford, Kia / Hyundai, Land Rover / Jaguar (EDC16, EDC17, MD1, MEVD17, MSV/MSD (7X/8X/9X), MS45, DCM3.7, DCM6.x, PCR2.1, DCM3.4, SID201, SID208, SID803/803A, CRD1.xx, CRD2.xx, CRD3.xx, SID3xx, SID202-SID206, SID209-SID211, DCM3.5, EMS22xx, EMS24xx (test), SIM210 (test), SIM28/29 (test), DCM3.2, SIM2K, SID20x, MED17). Free: 3 removals/day.