P112F: MAP-MAF Correlation / O2 Sensor / Coolant Temp Fault
Complete diagnostic information, symptoms, and potential causes
Manufacturer-Specific Variations
This code (P112F) may have different meanings or additional parameters depending on your vehicle's make, model, and year. Always verify with your vehicle's service manual or a qualified technician before attempting repairs.
MAP-MAF Correlation / O2 Sensor / Coolant Temp Fault
Description
Manufacturer-specific: MAP-MAF correlation (BMW/universal), O2 sensor (Dodge), or radiator temp sensor (GMC) - verify manufacturer first
Common Symptoms
- Check Engine Light
- Poor engine performance
- Reduced fuel economy
- Rough idle or hesitation
- Failed emissions test
- Possible overheating (GMC)
- Radiator fan running continuously (GMC)
Possible Causes
- FOR UNIVERSAL/BMW: Dirty or faulty MAF sensor
- FOR UNIVERSAL/BMW: Faulty MAP sensor
- FOR UNIVERSAL/BMW: Vacuum/intake air leaks
- FOR UNIVERSAL/BMW: Turbocharger issues (boost pressure)
- FOR UNIVERSAL/BMW: Sticking throttle body (carbon buildup)
- FOR UNIVERSAL/BMW: Faulty IAT, boost, or EGR sensors
- FOR DODGE: Air leaks in exhaust manifold or pipes
- FOR DODGE: Contaminated oxygen sensor (improper fuel/silicone)
- FOR DODGE: Faulty control module
- FOR GMC: Faulty radiator coolant temperature (RCT) sensor
- FOR GMC: Electrical issues - cut wiring, corroded connector
- FOR GMC: Low coolant level, air bubbles, stuck thermostat
- FOR GMC: ECM 5V signal or reference circuit damaged
Diagnosis Steps
- IDENTIFY MANUFACTURER FIRST - different meanings for BMW/Universal, Dodge, GMC
- FOR BMW/UNIVERSAL: Check MAF and MAP sensor readings with scanner
- FOR BMW/UNIVERSAL: Inspect for vacuum leaks in intake system
- FOR BMW/UNIVERSAL: Check throttle body for carbon buildup
- FOR BMW/UNIVERSAL: Test turbocharger boost pressure if applicable
- FOR DODGE: Check for exhaust manifold or pipe leaks
- FOR DODGE: Test O2 sensor readings during power enrichment
- FOR DODGE: Inspect O2 sensor for contamination
- FOR GMC: Compare RCT and ECT readings after engine off (should be within 10°C)
- FOR GMC: Test RCT sensor resistance (cold: ~3500Ω at 20°C, hot: ~200Ω at 90°C)
- FOR GMC: Check 5V reference voltage at sensor connector
- FOR GMC: Inspect coolant level and thermostat operation
Repair Solutions
- FOR BMW/UNIVERSAL: Clean or replace MAF sensor
- FOR BMW/UNIVERSAL: Replace faulty MAP sensor
- FOR BMW/UNIVERSAL: Repair vacuum leaks
- FOR BMW/UNIVERSAL: Clean throttle body
- FOR BMW/UNIVERSAL: Address turbocharger issues
- FOR DODGE: Repair exhaust leaks
- FOR DODGE: Replace contaminated oxygen sensor
- FOR DODGE: Replace control module if faulty
- FOR GMC: Replace faulty RCT sensor (OEM recommended - ACDelco 213-4484)
- FOR GMC: Repair damaged wiring or connectors
- FOR GMC: Replace stuck thermostat (30-100€)
- FOR GMC: Refill coolant and bleed air from system
- FOR GMC: Reprogram or replace ECM if internal fault (500-1200€)
Prevention Tips
- Always verify manufacturer before diagnosis
- Regular intake system inspection
- Use quality fuel to prevent O2 sensor contamination
- For GMC: Use Dex-Cool coolant to prevent corrosion
- For GMC: Monitor coolant temperature regularly
- Address engine performance issues promptly
Working with ECU firmware? Remove DTCs directly from firmware files
Our free Firmware DTC Remover detects and removes hardcoded fault codes directly from ECU firmware files — no software needed. Supports BMW / MINI, VAG (VW, Audi, Porsche, Skoda, Seat, Cupra), PSA (Peugeot, Citroën, DS), Mercedes-Benz, Renault / Dacia / Samsung, Ford, Kia / Hyundai, Land Rover / Jaguar (EDC16, EDC17, MD1, MEVD17, MSV/MSD (7X/8X/9X), MS45, DCM3.7, DCM6.x, PCR2.1, DCM3.4, SID201, SID208, SID803/803A, CRD1.xx, CRD2.xx, CRD3.xx, SID3xx, SID202-SID206, SID209-SID211, DCM3.5, EMS22xx, EMS24xx (test), SIM210 (test), SIM28/29 (test), DCM3.2, SIM2K, SID20x, MED17). Free: 3 removals/day.