P0973: Shift Solenoid A Control, Signal too Low

Complete diagnostic information, symptoms, and potential causes

⚠️

Manufacturer-Specific Variations

This code (P0973) may have different meanings or additional parameters depending on your vehicle's make, model, and year. Always verify with your vehicle's service manual or a qualified technician before attempting repairs.

P0973
Powertrain Code

Shift Solenoid A Control, Signal too Low

Transmission Control SystemMEDIUM👁 Views: 45

Description

Shift Solenoid A Control, Signal too Low

Common Symptoms

  • Check Engine Light for shift solenoid A signal too low
  • Weak shift solenoid A signals
  • Transmission shift low voltage warnings
  • Gear selection signal problems for solenoid A
  • Hydraulic valve control A voltage errors

Possible Causes

  • Low voltage supply to shift solenoid A
  • Solenoid A output signal weak
  • High resistance in shift solenoid A circuit
  • Shift solenoid A internal failure
  • Ground connection problems for shift solenoid A

Diagnosis Steps

  1. Check shift solenoid A signal voltage levels
  2. Verify voltage supply to shift solenoid A
  3. Test circuit resistance in shift solenoid A wiring
  4. Check shift solenoid A ground connections
  5. Inspect shift solenoid A for contamination
  6. Test shift solenoid A output characteristics

Repair Solutions

  • Fix low voltage supply to shift solenoid A
  • Replace shift solenoid A with weak output
  • Repair high resistance in shift solenoid A circuit
  • Address ground connection problems for shift solenoid A
  • Clean contaminated shift solenoid A connections
  • Replace internally failed shift solenoid A

Prevention Tips

  • Monitor shift solenoid A signals regularly
  • Maintain clean electrical connections
  • Check voltage supplies during maintenance
  • Address weak signals immediately
  • Protect shift solenoid circuits from contamination
⚡

Working with ECU firmware? Remove DTCs directly from firmware files

Our free Firmware DTC Remover detects and removes hardcoded fault codes directly from ECU firmware files — no software needed. Supports BMW / MINI, VAG (VW, Audi, Porsche, Skoda, Seat, Cupra), PSA (Peugeot, Citroën, DS), Mercedes-Benz, Renault / Dacia / Samsung, Ford, Kia / Hyundai, Land Rover / Jaguar (EDC16, EDC17, MD1, MEVD17, MSV/MSD (7X/8X/9X), MS45, DCM3.7, DCM6.x, PCR2.1, DCM3.4, SID201, SID208, SID803/803A, CRD1.xx, CRD2.xx, CRD3.xx, SID3xx, SID202-SID206, SID209-SID211, DCM3.5, EMS22xx, EMS24xx (test), SIM210 (test), SIM28/29 (test), DCM3.2, SIM2K, SID20x, MED17). Free: 3 removals/day.

Try DTC Remover — Free →