P0971: Pressure Control Solenoid 'C' Control, Signal too High

Complete diagnostic information, symptoms, and potential causes

⚠️

Manufacturer-Specific Variations

This code (P0971) may have different meanings or additional parameters depending on your vehicle's make, model, and year. Always verify with your vehicle's service manual or a qualified technician before attempting repairs.

P0971
Powertrain Code

Pressure Control Solenoid 'C' Control, Signal too High

Transmission Hydraulic SystemMEDIUM👁 Views: 45

Description

Pressure Control Solenoid 'C' Control, Signal too High

Common Symptoms

  • Check Engine Light for pressure control solenoid C signal too high
  • Excessive solenoid C pressure signals
  • Tertiary pressure overvoltage warnings
  • Auxiliary control protection errors
  • Additional shift regulation problems

Possible Causes

  • Overvoltage supply to pressure control solenoid C
  • Solenoid C output signal excessive
  • Short circuit in solenoid C wiring
  • Solenoid C internal short circuit
  • Voltage regulator problems for solenoid C

Diagnosis Steps

  1. Check pressure control solenoid C signal for overvoltage
  2. Verify voltage supply to solenoid C not excessive
  3. Test for shorts in solenoid C circuit
  4. Check solenoid C internal resistance
  5. Verify voltage regulation for solenoid C
  6. Test reference voltage to solenoid C

Repair Solutions

  • Fix overvoltage supply to pressure control solenoid C
  • Replace solenoid C with excessive output
  • Repair short circuit in solenoid C wiring
  • Replace solenoid C with internal short
  • Fix voltage regulator problems for solenoid C
  • Correct faulty reference voltage to solenoid C

Prevention Tips

  • Monitor pressure control solenoid C signals for overvoltage
  • Maintain proper voltage regulation
  • Check for wiring shorts regularly
  • Address excessive signals immediately
  • Protect solenoid C circuits from overvoltage
⚡

Working with ECU firmware? Remove DTCs directly from firmware files

Our free Firmware DTC Remover detects and removes hardcoded fault codes directly from ECU firmware files — no software needed. Supports BMW / MINI, VAG (VW, Audi, Porsche, Skoda, Seat, Cupra), PSA (Peugeot, Citroën, DS), Mercedes-Benz, Renault / Dacia / Samsung, Ford, Kia / Hyundai, Land Rover / Jaguar (EDC16, EDC17, MD1, MEVD17, MSV/MSD (7X/8X/9X), MS45, DCM3.7, DCM6.x, PCR2.1, DCM3.4, SID201, SID208, SID803/803A, CRD1.xx, CRD2.xx, CRD3.xx, SID3xx, SID202-SID206, SID209-SID211, DCM3.5, EMS22xx, EMS24xx (test), SIM210 (test), SIM28/29 (test), DCM3.2, SIM2K, SID20x, MED17). Free: 3 removals/day.

Try DTC Remover — Free →