P0968: Pressure Control Solenoid 'C' Control, Circuit Open

Complete diagnostic information, symptoms, and potential causes

⚠️

Manufacturer-Specific Variations

This code (P0968) may have different meanings or additional parameters depending on your vehicle's make, model, and year. Always verify with your vehicle's service manual or a qualified technician before attempting repairs.

P0968
Powertrain Code

Pressure Control Solenoid 'C' Control, Circuit Open

Transmission Hydraulic SystemHIGH👁 Views: 46

Description

Pressure Control Solenoid 'C' Control, Circuit Open

Common Symptoms

  • Check Engine Light for pressure control solenoid C circuit open
  • Tertiary pressure regulation failures
  • Additional shift control problems
  • Auxiliary hydraulic control warnings
  • Solenoid C circuit open errors

Possible Causes

  • Open circuit in pressure control solenoid C wiring
  • Broken wires in solenoid C circuit
  • Disconnected solenoid C connectors
  • Solenoid C internal open circuit
  • Fuse or circuit protection failures for solenoid C

Diagnosis Steps

  1. Test pressure control solenoid C circuit continuity
  2. Check for open wiring in solenoid C circuit
  3. Verify connector connections for solenoid C
  4. Test solenoid C internal circuit continuity
  5. Check fuse and circuit protection for solenoid C
  6. Verify wiring harness integrity for solenoid C

Repair Solutions

  • Repair open circuit in pressure control solenoid C wiring
  • Fix broken wires in solenoid C circuit
  • Reconnect disconnected solenoid C connectors
  • Replace solenoid C with internal open circuit
  • Fix fuse or circuit protection issues for solenoid C
  • Repair wiring harness problems for solenoid C

Prevention Tips

  • Regular pressure control solenoid C circuit checks
  • Monitor tertiary pressure regulation operation
  • Maintain clean electrical connections
  • Address open circuit warnings promptly
  • Check wiring harness routing for solenoid C
⚡

Working with ECU firmware? Remove DTCs directly from firmware files

Our free Firmware DTC Remover detects and removes hardcoded fault codes directly from ECU firmware files — no software needed. Supports BMW / MINI, VAG (VW, Audi, Porsche, Skoda, Seat, Cupra), PSA (Peugeot, Citroën, DS), Mercedes-Benz, Renault / Dacia / Samsung, Ford, Kia / Hyundai, Land Rover / Jaguar (EDC16, EDC17, MD1, MEVD17, MSV/MSD (7X/8X/9X), MS45, DCM3.7, DCM6.x, PCR2.1, DCM3.4, SID201, SID208, SID803/803A, CRD1.xx, CRD2.xx, CRD3.xx, SID3xx, SID202-SID206, SID209-SID211, DCM3.5, EMS22xx, EMS24xx (test), SIM210 (test), SIM28/29 (test), DCM3.2, SIM2K, SID20x, MED17). Free: 3 removals/day.

Try DTC Remover — Free →