P035C: Ignition Coil (L) Cylinder 12 Primary/Secondary, Malfunction

Complete diagnostic information, symptoms, and potential causes

⚠️

Manufacturer-Specific Variations

This code (P035C) may have different meanings or additional parameters depending on your vehicle's make, model, and year. Always verify with your vehicle's service manual or a qualified technician before attempting repairs.

P035C
Powertrain Code

Ignition Coil (L) Cylinder 12 Primary/Secondary, Malfunction

Ignition SystemHIGH👁 Views: 43

Description

Ignition coil L cylinder 12 primary/secondary malfunction

Common Symptoms

  • Check Engine Light with cylinder 12 ignition coil malfunction
  • Cylinder 12 specific misfire detection
  • Engine vibration correlated to cylinder 12 firing
  • Rough idle from cylinder 12 combustion issues
  • Reduced engine power from cylinder 12 inefficiency
  • Poor combustion specifically in cylinder 12

Possible Causes

  • Failed ignition coil for cylinder 12
  • Open or short circuit in cylinder 12 coil wiring
  • Cylinder 12 coil connector or terminal problems
  • Wiring harness damage specific to cylinder 12
  • Coil driver circuit issues for cylinder 12
  • Engine control module cylinder 12 output failure

Diagnosis Steps

  1. Test cylinder 12 ignition coil resistance
  2. Check cylinder 12 coil circuit continuity
  3. Inspect cylinder 12 coil connector and terminals
  4. Verify wiring harness to cylinder 12
  5. Test coil driver circuit for cylinder 12
  6. Swap coil with another cylinder for diagnosis

Repair Solutions

  • Replace failed cylinder 12 ignition coil
  • Repair cylinder 12 coil circuit problems
  • Clean or replace cylinder 12 coil connector
  • Fix wiring harness damage to cylinder 12
  • Address coil driver circuit issues
  • Reset engine adaptations after repair

Prevention Tips

  • Regular cylinder-specific ignition checks
  • Protect coil wiring from heat and vibration
  • Address cylinder-specific issues promptly
⚡

Working with ECU firmware? Remove DTCs directly from firmware files

Our free Firmware DTC Remover detects and removes hardcoded fault codes directly from ECU firmware files — no software needed. Supports BMW / MINI, VAG (VW, Audi, Porsche, Skoda, Seat, Cupra), PSA (Peugeot, Citroën, DS), Mercedes-Benz, Renault / Dacia / Samsung, Ford, Kia / Hyundai, Land Rover / Jaguar (EDC16, EDC17, MD1, MEVD17, MSV/MSD (7X/8X/9X), MS45, DCM3.7, DCM6.x, PCR2.1, DCM3.4, SID201, SID208, SID803/803A, CRD1.xx, CRD2.xx, CRD3.xx, SID3xx, SID202-SID206, SID209-SID211, DCM3.5, EMS22xx, EMS24xx (test), SIM210 (test), SIM28/29 (test), DCM3.2, SIM2K, SID20x, MED17). Free: 3 removals/day.

Try DTC Remover — Free →