P0354: Ignition Coil (D) Cylinder 4 Primary/Secondary, Malfunction

Complete diagnostic information, symptoms, and potential causes

⚠️

Manufacturer-Specific Variations

This code (P0354) may have different meanings or additional parameters depending on your vehicle's make, model, and year. Always verify with your vehicle's service manual or a qualified technician before attempting repairs.

P0354
Powertrain Code

Ignition Coil (D) Cylinder 4 Primary/Secondary, Malfunction

Ignition SystemHIGH👁 Views: 44

Description

Ignition coil D cylinder 4 primary/secondary malfunction

Common Symptoms

  • Check Engine Light with cylinder 4 ignition coil malfunction
  • Cylinder 4 specific misfire detection
  • Engine vibration correlated to cylinder 4 firing
  • Rough idle from cylinder 4 combustion issues
  • Reduced engine power from cylinder 4 inefficiency
  • Poor combustion specifically in cylinder 4

Possible Causes

  • Failed ignition coil for cylinder 4
  • Open or short circuit in cylinder 4 coil wiring
  • Cylinder 4 coil connector or terminal problems
  • Wiring harness damage specific to cylinder 4
  • Coil driver circuit issues for cylinder 4
  • Engine control module cylinder 4 output failure

Diagnosis Steps

  1. Test cylinder 4 ignition coil resistance
  2. Check cylinder 4 coil circuit continuity
  3. Inspect cylinder 4 coil connector and terminals
  4. Verify wiring harness to cylinder 4
  5. Test coil driver circuit for cylinder 4
  6. Swap coil with another cylinder for diagnosis

Repair Solutions

  • Replace failed cylinder 4 ignition coil
  • Repair cylinder 4 coil circuit problems
  • Clean or replace cylinder 4 coil connector
  • Fix wiring harness damage to cylinder 4
  • Address coil driver circuit issues
  • Reset engine adaptations after repair

Prevention Tips

  • Regular cylinder-specific ignition checks
  • Protect coil wiring from heat and vibration
  • Address cylinder-specific issues promptly
⚡

Working with ECU firmware? Remove DTCs directly from firmware files

Our free Firmware DTC Remover detects and removes hardcoded fault codes directly from ECU firmware files — no software needed. Supports BMW / MINI, VAG (VW, Audi, Porsche, Skoda, Seat, Cupra), PSA (Peugeot, Citroën, DS), Mercedes-Benz, Renault / Dacia / Samsung, Ford, Kia / Hyundai, Land Rover / Jaguar (EDC16, EDC17, MD1, MEVD17, MSV/MSD (7X/8X/9X), MS45, DCM3.7, DCM6.x, PCR2.1, DCM3.4, SID201, SID208, SID803/803A, CRD1.xx, CRD2.xx, CRD3.xx, SID3xx, SID202-SID206, SID209-SID211, DCM3.5, EMS22xx, EMS24xx (test), SIM210 (test), SIM28/29 (test), DCM3.2, SIM2K, SID20x, MED17). Free: 3 removals/day.

Try DTC Remover — Free →