P0204: Injector Cylinder 4 (N33), Circuit Malfunction
Complete diagnostic information, symptoms, and potential causes
Manufacturer-Specific Variations
This code (P0204) may have different meanings or additional parameters depending on your vehicle's make, model, and year. Always verify with your vehicle's service manual or a qualified technician before attempting repairs.
Injector Cylinder 4 (N33), Circuit Malfunction
Description
Fuel injector cylinder 4 (N33), circuit malfunction
Common Symptoms
- Check Engine Light indicating cylinder 4 injector issue
- Detectable misfire in cylinder 4
- Engine vibration, especially noticeable under acceleration
- Reduced overall engine performance and power
- Possible fuel smell from exhaust due to unburned fuel
- Poor cold start performance
Possible Causes
- Defective fuel injector for cylinder 4
- Open circuit in cylinder 4 injector wiring
- Short circuit affecting cylinder 4 injector
- Damaged or corroded connector at cylinder 4 injector
- Faulty ECU injector driver circuit for cylinder 4
- Wiring harness issue specific to cylinder 4 area
Diagnosis Steps
- Perform injector swap test with cylinder 4 and another cylinder
- Test electrical continuity of cylinder 4 injector circuit
- Measure injector coil resistance for cylinder 4
- Verify injector pulse signal using diagnostic equipment
- Inspect wiring and connections in cylinder 4 area
- Check ECU driver circuit functionality for cylinder 4
Repair Solutions
- Replace faulty cylinder 4 fuel injector
- Repair wiring issues in cylinder 4 injector circuit
- Clean or replace damaged electrical connectors
- Replace ECU if cylinder 4 injector driver circuit is defective
- Repair any harness damage near cylinder 4
- Reset fuel trims and perform adaptation after repair
Prevention Tips
- Regular fuel system maintenance including injector cleaning
- Protect electrical wiring from heat and moisture
- Address engine performance issues promptly
Working with ECU firmware? Remove DTCs directly from firmware files
Our free Firmware DTC Remover detects and removes hardcoded fault codes directly from ECU firmware files — no software needed. Supports BMW / MINI, VAG (VW, Audi, Porsche, Skoda, Seat, Cupra), PSA (Peugeot, Citroën, DS), Mercedes-Benz, Renault / Dacia / Samsung, Ford, Kia / Hyundai (EDC16, EDC17, MD1, MEVD17, MSV/MSD (7X/8X/9X), MS45, DCM3.7, DCM6.x, PCR2.1, DCM3.4, SID201, SID208, SID803/803A, Delphi CRD1.xx DCM3.2, Delphi CRD2.xx DCM3.5, Delphi CRD3.xx, SID3xx (307, 310), EDC16 (C3, C36, CP33, C41, CP42), EDC17 (C42, C11, CP19, C84), MD1CS006, SID3xx (301, 305, 307, 309, 310), SID202-SID206, SID209-SID211, EDC17 (C10, CP65, C70), Delphi DCM 3.5, Delphi DCM 6.x, Siemens/Continental EMS22xx, Siemens/Continental EMS24xx (test), Siemens SIM210 (test), Siemens SIM28/29 (test), EDC16 (C39, CP34)). Free: 3 removals/day.