P0202: Injector Cylinder 2 (N31), Circuit Malfunction

Complete diagnostic information, symptoms, and potential causes

⚠️

Manufacturer-Specific Variations

This code (P0202) may have different meanings or additional parameters depending on your vehicle's make, model, and year. Always verify with your vehicle's service manual or a qualified technician before attempting repairs.

P0202
Powertrain Code

Injector Cylinder 2 (N31), Circuit Malfunction

Fuel SystemHIGH👁 Views: 204

Description

Fuel injector cylinder 2 (N31), circuit malfunction

Common Symptoms

  • Check Engine Light with cylinder 2 specific code
  • Misfire detected in cylinder 2
  • Rough engine operation especially under load
  • Engine vibration that may vary with RPM
  • Reduced overall engine power
  • Decreased fuel efficiency

Possible Causes

  • Failed fuel injector in cylinder 2
  • Open circuit in cylinder 2 injector wiring
  • Short circuit in injector harness for cylinder 2
  • Poor connection at cylinder 2 injector connector
  • Faulty ECU injector driver for cylinder 2
  • Damaged wiring near cylinder 2

Diagnosis Steps

  1. Perform injector swap test between cylinder 2 and another cylinder
  2. Test electrical continuity of cylinder 2 injector circuit
  3. Measure injector coil resistance for cylinder 2
  4. Check for injector pulse using diagnostic tool
  5. Inspect wiring harness for damage near cylinder 2
  6. Verify ECU driver signal output for cylinder 2

Repair Solutions

  • Replace defective cylinder 2 fuel injector
  • Repair any wiring issues in cylinder 2 injector circuit
  • Clean or replace cylinder 2 injector electrical connector
  • Replace ECU if cylinder 2 injector driver circuit is faulty
  • Repair damaged harness sections affecting cylinder 2
  • Clear codes and test drive to verify repair

Prevention Tips

  • Regular fuel system maintenance to prevent injector clogging
  • Protect injector wiring from excessive heat and vibration
  • Address engine misfires promptly to prevent further damage
⚡

Working with ECU firmware? Remove DTCs directly from firmware files

Our free Firmware DTC Remover detects and removes hardcoded fault codes directly from ECU firmware files — no software needed. Supports BMW / MINI, VAG (VW, Audi, Porsche, Skoda, Seat, Cupra), PSA (Peugeot, Citroën, DS), Mercedes-Benz, Renault / Dacia / Samsung, Ford, Kia / Hyundai (EDC16, EDC17, MD1, MEVD17, MSV/MSD (7X/8X/9X), MS45, DCM3.7, DCM6.x, PCR2.1, DCM3.4, SID201, SID208, SID803/803A, Delphi CRD1.xx DCM3.2, Delphi CRD2.xx DCM3.5, Delphi CRD3.xx, SID3xx (307, 310), EDC16 (C3, C36, CP33, C41, CP42), EDC17 (C42, C11, CP19, C84), MD1CS006, SID3xx (301, 305, 307, 309, 310), SID202-SID206, SID209-SID211, EDC17 (C10, CP65, C70), Delphi DCM 3.5, Delphi DCM 6.x, Siemens/Continental EMS22xx, Siemens/Continental EMS24xx (test), Siemens SIM210 (test), Siemens SIM28/29 (test), EDC16 (C39, CP34)). Free: 3 removals/day.

Try DTC Remover — Free →
← Back to OBD Codes List Home