P002C: Exhaust Cam Profile Control Bank 1 Signal too High
Complete diagnostic information, symptoms, and potential causes
Manufacturer-Specific Variations
This code (P002C) may have different meanings or additional parameters depending on your vehicle's make, model, and year. Always verify with your vehicle's service manual or a qualified technician before attempting repairs.
Exhaust Cam Profile Control Bank 1 Signal too High
Description
Exhaust (B) Cam Profile Control bank 1, Signal too High
Common Symptoms
- Stuck in high exhaust cam profile
- Possible excessive exhaust valve lift
- Check Engine Light
- Poor low-RPM exhaust performance
- Increased exhaust noise
Possible Causes
- Short to power in exhaust cam profile circuit
- Failed exhaust cam profile solenoid stuck on
- ECU exhaust driver circuit malfunction
- Wiring harness short to 12V on exhaust side
- Aftermarket exhaust system interference
Diagnosis Steps
- Test exhaust circuit for shorts to power
- Check exhaust cam profile solenoid mechanical operation
- Inspect exhaust wiring for damage
- Test ECU exhaust output signals
- Check for aftermarket exhaust modifications
Repair Solutions
- Repair shorted wiring to power on exhaust side
- Replace faulty exhaust cam profile solenoid
- Remove interfering aftermarket exhaust components
- Replace ECU if exhaust driver circuit failed
- Reset exhaust valve train adaptations
Prevention Tips
- Professional installation of exhaust upgrades
- Regular exhaust wiring inspection
- Avoid splicing into factory exhaust profile wiring
Working with ECU firmware? Remove DTCs directly from firmware files
Our free Firmware DTC Remover detects and removes hardcoded fault codes directly from ECU firmware files — no software needed. Supports BMW / MINI, VAG (VW, Audi, Porsche, Skoda, Seat, Cupra), PSA (Peugeot, Citroën, DS), Mercedes-Benz, Renault / Dacia / Samsung, Ford, Kia / Hyundai, Land Rover / Jaguar (EDC16, EDC17, MD1, MEVD17, MSV/MSD (7X/8X/9X), MS45, DCM3.7, DCM6.x, PCR2.1, DCM3.4, SID201, SID208, SID803/803A, Delphi CRD1.xx DCM3.2, Delphi CRD2.xx DCM3.5, Delphi CRD3.xx, SID3xx (307, 310), EDC16 (C3, C36, CP33, C41, CP42), EDC17 (C42, C11, CP19, C84), MD1CS006, SID3xx (301, 305, 307, 309, 310), SID202-SID206, SID209-SID211, EDC17 (C10, CP65, C70), Delphi DCM 3.5, Delphi DCM 6.x, Siemens/Continental EMS22xx, Siemens/Continental EMS24xx (test), Siemens SIM210 (test), Siemens SIM28/29 (test), EDC16 (C39, CP34), DCM3.2, Siemens SIM2K, Siemens SID20x, MED17 (9.9, 9.7, 2, 8.31, 8.32)). Free: 3 removals/day.